Plumbing Industry Climate Action Centre

Geothermal Industries was involved in the early stages of the project and was selected to initially drill a test hole to 100m on the site for a Thermal Conductivity Test.

During the drilling of the test well it became apparent that the swelling clays extended to a greater depth than anticipated. This had presented a challenge given the current drilling equipment being used in the initial test drilling and Geothermal Industries recognised that it would need to source a different drilling technology to complete the project.

After adding to it’s fleet a new specialised Commachio drill from Italy, Geothermal Industries was selected to proceed with the overall project of drilling 28 geothermal bores to a depth of 100m. Despite the difficult drilling conditions Geothermal Industries was able to drive casing past the troublesome zones and complete each borehole as per the intended schedule.

During the install of each of the 28 bores GIA were happy to report a 100% success rate of getting each ground heat exchanger installed to depth on the 1st attempt. In addition to drilling the 2800m of vertical bores Geothermal Industries also installed 2500m of energy pile piping including grouting with an enhanced thermally conductive grout.

Geothermal Industries Australia Pty Ltd

0437 973 583
info@geothermalindustries.com.au
17 Paramount Boulevard, Cranbourne West, VIC 3977

ACN 605 463 018
ABN 92 605 463 018

Geothermal Industries acknowledges the original custodians of Australia and respects the language, law and culture of all Australia’s Indigenous Nations.

Scroll to Top